Loading

PWM+RGB HUB V1.5

PWM+RGB HUB V1.5 RGB HUB function description
1. Power on the lnitial state of the lights off
2. Short press the button light from(white),and then every time, the color of the light convesion once order
3. Support RGB SYNC with motherboaard
4. 5xChannel normal 3PIN fan by PWM control
5. Total 5 channel RGB contro via build-in program or SYNC with motherboard

PWM+RGB HUB V1.5

RGB Lamp function description
1. Power on the lnitial state of the lights off
2. Short press the button light from(white),and then every time, the color of the light convesion once order (White,Blue, yellow, red ,green,orange,purple,breath, flashing ,a total of9 models)
3. Breathing pattern description, light from the light to 2 seconds, and then from light to dark 2 seconds,the color from white to start, in accordance with the white, blue,yellow, red, green,orange,purple sequential non-stop cycle.Press a button again to enter the blinking model
4. Flashing model desc,iptionc lamp to 4HZ frequency of 2 seconds afte, switching the color , In accordance with the white, blue, yellow, red ,green,orange,purple sequential non-stop cycle.Press a button to ente, the white light often bright mode.
5. In any mode, press the button fo, 3 seconds, Press the button again to enter, the white light normal bright model ,according to this cycle

Fan control function description
Before PCB board being Installed , CPU-FAN should be connected with CHA-FAN and CMOS Is set Into not to check CPU-FAN

image.png

PWM+RGB HUB V1.5

Demonstration about the design of the switch color:
1. If the PWM cable's connector is connected with the RGB interface, the computer will Reset
2. If the PWM cable's connector is connected with the On/OFF fan interface, the IC of Controller PCB will be destroyed.
3. if the On/OFF switch connector is connected with the PWM interface, no function, but no damaged Controller PCB
4. If the On/OFF switch connector is connected with the RGB interface, the color of  the RGB light will change, but the control board won't be destroyed.
5. If the RGB switch connector is connected with the On/OFF fan interface, the control board won't be destroyed
6. If the RGB switch connector is connected with the PWM interface, the control board won't be destroyed

In order to prevent misplugging, we designed the plug as follows:
1. The 3+4P of 1/2/3/4/S (FAN+RGB) plug Is black
2. The 6 (PWM) plug;, cream-colored
3. The 7 (Power Supply);, white
4. The 8 (key) ; black

RGB-PWM Control panel interface definition
1. 1/2/3/4/5 for 3+4P(2.54) interface, the 3P for fan, the 4P for RGB color light.
2. The RGB interface of 1/2/3/4/5 can be connect RGB of fao or RGB strip.
3. 6 for the motheboaard CPU-FAN ,
4, The Plug of 7 is a floppy 4P interface which is connected with PC Power Supply.
5. The Plug of 8 is the connector switch of fan (WHITE COLOR!) and RGB switch of RGB (BLACK COLOR!)

image.png

热门推荐